DM9000B: Fix PHY power for network down/up

DM9000 revision B needs 1 ms delay after PHY power-on.
PHY must be powered on by writing 0 into register DM9000_GPR before
all other settings will change (see Davicom spec and example code).

Remember, that register DM9000_GPR was not changed by reset sequence.

Without this fix the FIFO is out of sync and sends wrong data after
sequence of "ifconfig ethX down ; ifconfig ethX up".

Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
Henry Nestler 2011-02-22 11:29:42 +00:00 committed by David S. Miller
parent 8dde924217
commit 108f518cc4

View File

@ -802,10 +802,7 @@ dm9000_init_dm9000(struct net_device *dev)
/* Checksum mode */
dm9000_set_rx_csum_unlocked(dev, db->rx_csum);
/* GPIO0 on pre-activate PHY */
iow(db, DM9000_GPR, 0); /* REG_1F bit0 activate phyxcer */
iow(db, DM9000_GPCR, GPCR_GEP_CNTL); /* Let GPIO0 output */
iow(db, DM9000_GPR, 0); /* Enable PHY */
ncr = (db->flags & DM9000_PLATF_EXT_PHY) ? NCR_EXT_PHY : 0;
@ -1194,6 +1191,10 @@ dm9000_open(struct net_device *dev)
if (request_irq(dev->irq, dm9000_interrupt, irqflags, dev->name, dev))
return -EAGAIN;
/* GPIO0 on pre-activate PHY, Reg 1F is not set by reset */
iow(db, DM9000_GPR, 0); /* REG_1F bit0 activate phyxcer */
mdelay(1); /* delay needs by DM9000B */
/* Initialize DM9000 board */
dm9000_reset(db);
dm9000_init_dm9000(dev);